Tutorial to act in case of emergency charging need
If you Landroid does not power up when turned on it can be than Landroid it is completely discharged due to an unexpected event. This is a rare vent that can be easily fixed.
In this case you should operate an emergency charge, depending on your Landroid model please follow the steps below:
S, M, L LED DISPLAY and LCD DISPLAY - LCD DISPLAY + KNOB
WR130E, WR139E, WR140, WR140E, WR141E, WR142E, WR143E, WR147, WR147E, WR147E.1, WR148E, WR149E, WR150, WR150E, WR153E, WR155, WR155E, WR165, WR165E, WR167E, WR184E
Manually dock it to charge, making sure the contact pins touch in the middle the contacts on the charging base, and the emergency charging will start.
When the charge is completed, power Landroid on and it will operate accordingly to its schedule.
S 2017/2018
WR090S, WR091S, WR092S, WR093S, WR094S, WR095S, WR096S, WR100SI, WR101SI, WR101SI.1, WR102SI, WR102SI.1, WR103SI, WR104SI, WR104SI.1, WR105SI, WR105SI.1, WR106SI, WR106SI.1, WR110MI, WR110MI.1, WR115MI
Please proceed as per steps below:
1. Turn your Landroid off
2. Manually dock it to charge. The charging station LED will turn from green to red, the battery symbol will blink red and green for about an hour and half. The charge is completed when the red LED on the base truns green
You don't need to wait for the entire charge cycle, Landroid can go back to work after approximately one hour
3. Turn the power on
Attention: when an emergency charge is performed your Landroid remains in standby mode, waiting for instructions even once the main switch has been turned on.
In order to restore full functionality, you have two options:
A. Press START then OK. Landroid will start work immediately
B. Take your Landroid out of the base and press HOME/OK. Landroid will return to base and operate according to schedule.
Watch the video
M, L 2016/2018
WG754E, WG755E, WG756E, WG757E, WG758E, WG790E.1, WG791E.1, WG792E.1, WG793E.1, WG796E.1, WG797E.1, WG798E, WG799E, WR111MI, WR112MI, WR113MI
1. Place manually your Landroid on the charging base
2. As the led of the charging base will light on, please turn on your Landroid
3. The charge is completed when the red LED on the base turns green. Landroid will then operate accordingly to its schedule.