Skip to Content
Landroid Vision Installation, Setup and Usage
Initial Start-Up, Quick Start Mowing, and Operation (WR202E Only)
Initial Power-On and PIN Entry (WR202E)
After positioning Landroid Vision in the charging station and allowing it to charge, press and hold the power button for 3 seconds until the display lights up.
Enter the default PIN code “0000” by pressing the button three times.
Press the button again to confirm.
The screen will display “IDLE,” indicating standby mode.
Quick Start Mowing – “Start, OK!” (WR202E)
To start mowing immediately, press the start button, then press the OK button.
If the screen displays “St:En,” press the OK button to confirm.
Landroid Vision will emit four beeps before beginning operation.
Zone Confirmation Prompts (WR202E)
If Landroid Vision does not recognize its current location, it will ask you to confirm the cutting area:
Situation 1: If powered on outside the charging station and you press Start and OK, the screen will display “Ar:En.” Press OK to confirm mowing in the current area.
Situation 2: If the mower is lifted for more than 3 seconds outside the charging station and you press Start and OK, the screen will again display “Ar:En.” Press OK to confirm.
Returning to the Charging Station (WR202E)
Press the Stop button to stop mowing.
Press the Home button, then press the OK button to confirm.