Skip to Content
Landroid Vision Installation, Setup and Usage
Initial Start-Up, Quick Start Mowing, and Operation (Non-WR202E)
Initial Power-On and PIN Entry
After positioning Landroid Vision in the charging station and allowing it to charge, press and hold the power button until the display lights up.
Enter the default PIN code “0000” by pressing the button three times.
The display will show “0000.” Press the button again to confirm.
The display will show “PIN code OK.”
Quick Start Mowing – “Start, OK!”
To start mowing immediately, press the start button, then press the OK button.
If the screen displays “Is it the identified mowing zone?”, press the OK button to confirm.
Before operation begins, Landroid Vision will emit four beeps as an audio signal.
Returning to the Charging Station
To send Landroid Vision back to the charging station, press the Stop button to stop mowing.
Then press the Home button, followed by the OK button to confirm.