Landroid Vision Error and Status Messages

Case 1 – Boundary not clear

Cause:

The mower cannot detect the lawn boundary because it is unclear (slopes, uneven ground, curbs, debris, or overgrown grass).

Solution:

• Keep the border flat and even.

• Remove leaves, debris, or overgrown grass.

• Make the boundary more visible if needed: barriers, magnetic strips, or treating patchy grass.

Case 2 – Magnetic strip issue

Cause:

The mower cannot follow the magnetic strip because it is installed incorrectly or covered.

Solution:

• Keep strip at least 32 cm from the edge.

• Do not bury it.

• Install on flat grass.

• Remove leaves or obstacles.

Case 3 – Mower started outside the mowing area

Cause:

The mower was placed or started outside the mowing area.

Solution:

• Always start inside the mowing area near the charging base.

• Do not start from gravel, paths, or outside the lawn.

Case 4 – Terrain or traction problem

Cause:

The mower leaves the mowing area due to steep edges, holes, narrow passages, or slipping on wet grass.

Solution:

• Fill in holes or make them smooth.

• Avoid steep drops.

• Widen narrow passages.

• Operate on dry grass.

• Clean wheels and check treads.

Case 5 – Lighting conditions

Cause:

Poor lighting (too dark, strong shadows, or glare) prevents border detection.

Solution:

• Use mower in daylight.

• Avoid very dark or glaring conditions.

• Adjust schedule to brighter times.

• Clean camera lens.